说明:
1. 本文档提取自部分PCB信息和部分smartdrill层信息，文档不能替代smartdrill层，仅用于板厂工程文件制作IT效率的提升。
2. 如板厂没有IT系统识别能力，请忽略此文档。如需建立相关IT能力，请联系TQC。
3. 使用本文档必须与光绘文件校验，当出现与光绘文件有矛盾时，以光绘文件为准。

Readme:
1. This document is extracted from some PCB information and some SmartDrill layer information. It cannot replace the SmartDrill layer, it is only used to improve the IT efficiency of engineering document preparation for vendors.
2. If the vendor does not have the IT identification capability, please ignore this document. If the vendor wants to build IT capability, please contact the TQC.
3. If this document is used to improve IT efficiency, it must be verified with the Gerber file. If the document conflicts with the Gerber file, the Gerber file must be prevailed.



#START_FILE#


#START_SYS#
PCBDesigner=S1
Version=V.1.3
#END_SYS#



#START_ATTRS#
#END_ATTRS#



#START_TABLELIST#

#START_TABLE#
[ "DRILL CHART: TOP to BOTTOM" ]
[ "ALL UNITS ARE IN MILS" ]
[ "FIGURE" , "SIZE" , "PLATED" , "QTY" ]
[ "" , "8.0" , "PLATED" , "3640" ]
[ "" , "12.0" , "PLATED" , "32" ]
[ "" , "45.0" , "PLATED" , "10" ]
[ "" , "52.0" , "PLATED" , "6" ]
[ "" , "54.0" , "PLATED" , "2" ]
[ "" , "110.0" , "PLATED" , "10" ]
[ "" , "40.0" , "NON-PLATED" , "40" ]
[ "" , "50.0" , "NON-PLATED" , "2" ]
[ "" , "120.0" , "NON-PLATED" , "6" ]
[ "" , "138.0" , "NON-PLATED" , "4" ]
[ "" , "100.0x32.0" , "PLATED" , "1" ]
[ "" , "110.0x32.0" , "PLATED" , "1" ]
[ "" , "120.0x32.0" , "PLATED" , "1" ]
#END_TABLE#

#END_TABLELIST#

#END_FILE#
